Draper BDS368 El manual del propietario

BELT ANDDISC SANDER STOCK No.50021 PART No.BDS368• INSTRUCTIONS •IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THESAFE AND EFFEC

INSTALLING THE BACK STOP (Fig.7):Fix the back stop ✰✌ in place on theback of the sanding belt assembly andadjust it with 1.5mm gap to allowsawdust to

SAW DUST EXTRACTION (Fig.11):It is recommended that the sander isconnected to a vacuum cleaner (forexample Draper Stock No.64674) duringoperation, whi

Fig.13Fig.14- 11 -STRAIGHT SANDING (Fig.13):Hold the work firmly with both hands,keeping fingers away from the belt.Straight pieces shorter than the b

- 12 -CONTOUR SANDING (Fig.15):Inside contours: Inside curves can besanded on the drums at either end ofthe machine. Hold the work firmly, pressthe co

- 13 -REPLACING THE SANDING BELT ANDTRACKING (Fig.17):WARNING - TO AVOID INJURY FROMACCIDENTAL STARTING, TURN THEPOWER SWITCH “OFF” AND REMOVETHE PLUG

- 14 -TROUBLE SHOOTINGMAINTENANCEWARNING: FOR YOUR OWN SAFETY, TURNSWITCH “OFF” AND REMOVE THE PLUGFROM THE POWER SUPPLY OUTLET BEFOREADJUSTING, MAINT

- 15 -OPTIONAL ACCESSORIESThe following accessories are available from your local Draper stockist:SANDING DISCS:PART No. STOCK No. GRIT GRADE PACK QUA

- 16 -NOTES

NOTES- 17 -

NOTES- 18 -

BELT AND DISC SANDER STOCK No.50021 PART No.BDS368CONTENTS: Page No.Contents/Declaration ...

DRAPER TOOLS LIMITED,Hursley Road, Chandler's Ford, Eastleigh, Hants. SO53 1YF. U.K.Helpline: (023) 8049 4344.Sales Desk: (023) 8049 4333.General

- 2 -The Draper Tools policy of continuous improvement determines the right to change specificationwithout notice.Part No. ...

- 3 -CONNECTING YOUR MACHINE TO THE POWER SUPPLY: (230V ONLY)To eliminate the possibility of an electric shock your machine has been fitted with a BSa

- 4 -GENERAL SAFETY INSTRUCTIONSFOR POWER TOOLS1. KNOW YOUR POWER TOOLRead and understand the owner's manual and labelsaffixed to the tool. Lear

- 5 -ADDITIONAL SAFETY RULESFOR BELT & DISC SANDERSSAFETYSafety is a combination of operator common sense and alertness at all times when the sand

Carefully unpack the sander and all the loose parts from the carton.Fig.1 illustrates the sander and all the associated parts. Check that all of the p

- 7 -1. Sanding disc 9. Sanding belt2. Work table 10. Backstop3. Mitre gauge 11. Dust extraction outlet4. Disc guard 12. Sanding plate5. Table tilt lo

MOUNTING THE SANDER TO AWORKBENCH (Fig.3):The sander should be fastened securelyto a firm supporting surface such as aworkbench. If mounting to a work