Draper SC1 Manual de instrucciones descargar pdf (Pagina 16)

Universal RTS Interface II

Back of Interface control box

Antenna

IR Sensor Input

RS232 Input

or RS485 Input

RS485 Input/Output

Power

Front of Interface control box

UP Button

STOP Button

Power/Transmit LED

URTSI Address or

RTS Channel

Rotary Switch

Program Button

DOWN Button

Pin 4

Pin 1

IR Signal

Common

+5V DC

IR Sensor Modular Pin-Out

(Shown Tab-side Down)

Pin 8

Pin 1

RS485 A

Common

+5V DC

RS232/RS485 Pin-Out

(Shown Tab-side Down)

RS485 B

RS232 RX

RS232 TX

N/C

NOTE: Do Not remove antenna.

If a new antenna is needed, it

must be ordered from Somfy to

ensure FCC requirements are

maintained.

The addressable Universal RTS Interface II (URTSI II) can be used to

communicate between home automation or other third party systems and

RTS Motors and controls. It is capable of individual or group control, and

can be operated via infrared remote, RS232 and RS485 serial communi-

cation. Once an input is activated, an RTS radio command is sent to the

automated window treatment.

DESCRIPTION

Part Number: 1810872

CONNECTION DIAGRAM

FCC INFORMATION

This device complies with Part 15 of the FCC Results. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including that which may cause undesired operation.

NOTE: This equipment has been tested and found to comply with the limits for CLASS B digital device, pursuant to Part 15 of FCC Rules. These limits are

designed to provide reasonable protection against harmful

interference when the equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency energy and , if not

installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equip-

ment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of

the following measures:

1. Reorient or relocate the receiving antenna

2. Increase the separation between the equipment and receiver

3. Connect the equipment into an outlet on a circuit different from that to which receiver is connected

4. Consult the dealer or experienced radio/TV technician for help.

WARNING

Changes or modiﬁ cations not expressly approved by the manufacturer could void the user’s authority to operate the equipment.

Page 16 of 120

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 119 120

Comentarios a estos manuales

Sin comentarios

Draper SC1 Manual de instrucciones Pagina 16

Comentarios a estos manuales

Relacionado con productos y manuales para No Draper SC1