Draper SC1 Manual de instrucciones descargar pdf (Pagina 18)

RS232 to RTS Interface

with X10 Compatibility

Description

The RS232 to RTS Interface is a 16-channel RTS transmitter that enables third party home automa-

tion systems to directly control Somfy’s line of RTS motors and controls. The interface also includes

X10 compatibility for direct control of RTS product from an X10 powerline system. The interface plugs

into a standard 115 VAC electrical outlet.

Part Number 1810686

Operating Procedures

RTS Channel Programming

➀ Ensure the RTS motor or receiver to be controlled has already been assigned to a channel on a Telis or similar channel as outlined in the

speciﬁ c product instructions. All limits, intermediate positions and programmable functions should be set.

➁ Set the RTS receiver or motor into its programming mode as outlined in the speciﬁ c product instructions.

➂ Set the Rotary Address Dial to the channel you want the motor or receiver to respond to. Press the Programming Button on the Interface.

The motor or receiver will respond accordingly.

RS232 Operation

➀ Set RS232 communication settings to: 9600 Baud, 8 Data Bits, 1 Stop Bit, No Parity

➁ Use the ASCII protocol: <!> <2 digit unit code> <Directional Command>

➂ The directional commands must be capital letters and are as follows:

U: up

D: down

S: stop

➃ There must be a 500mS delay between successive commands.

➄ Examples: Motor 2 Up: !02U

Motor 5 Down: !05D

Motor 1 Stop: !01S

X10 Operation

➀ Set the Rotary Address Dial to the desired X10 house code.

➁ Send the address then the following commands to activate

that motor or receiver:

BRIGHT: UP

DIM: DOWN

OFF: STOP

➂ Examples: Motor 1 Up: 1 Bright

Motor 3 Down: 3 Dim

Motor 5 Stop: 5 Off

Page 18 of 120

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 119 120

Sin comentarios

Draper SC1 Manual de instrucciones Pagina 18