Draper SC1 Manual de instrucciones descargar pdf (Pagina 74)

ILT Switch and Limit Sets

The ILT switch has a modular connector on the back to plug in the Intelligent Motor, once the motor is connected then limits can be set and

the shade can be operated. The ILT switch ﬁ ts into a single gang box with a decora face plate and is ﬂ ush with the plate.

Setting Limits on an Intelligent Motor Shade are as follows:

➀ Connect the ILT switch to motor via the modular cable port. The cable connectors MUST NOT be crimped in reverse as with

standard telephone cable.

➁ Set the slide switch to the lower position. Press and hold the down button to run the shade to the desired lower limit. If the shade moves

the opposite direction, release the button and depress the stop button. This will reverse the motor direction. You may then continue

running to the lower limit. Once at the lower limit move the slide switch to the middle position.

➂ Set the slide switch to the upper position. Move the shade to the desired upper limit by depressing the up button.

➃ Once at the upper limit move the slide switch to the middle position. When the slide switch is in the middle position, then the shade is in

user mode.

The shade will move in momentary fashion when the slide switch is up or down for setting limits.

To set an intermediate stop:

➀ Run the shade to the desired intermediate stop.

➁ Press the stop button for at least 3 seconds to record the position.

➂ Now when the shade is stopped, you may press the stop button to run it to the record intermediate stop position.

To Motor

with

Built-In

Low Voltage

Slide

Switch

Back View

To Motor

with

Built-In

Low Voltage

Page 74 of 120

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 119 120

Sin comentarios

Draper SC1 Manual de instrucciones Pagina 74